To Associate An X3D Gate Receiver (Tyxia 6410); To Associate X3D Lighting Receivers (Unit 1); To Associate Scenarios (4 Scenarios Can Be Created) - DELTA DORE TTRTC TYXAL+ Manual De Instalación

8. Association of home automation functions

8.6 To associate an X3D gate receiver (TYXIA 6410).

• Set the receiver to association wait mode (refer to the user guide).
• From the main menu, type #430 then type 1
• The transmitter displays: "Configuring..."
After a few seconds, the transmitter announces the number of receivers found on
the installation:
Example: "1 gate associated, 0 repeater associated".
Check that:
• the receiver LED has stopped flashing.

8.7 To associate X3D lighting receivers (unit 1)

• Set all the receivers to association wait mode (refer to the user guide).
• From the main menu, type #420 then type 1
• The transmitter displays: "Configuring..."
After a few seconds, the transmitter announces the number of receivers found on
the installation:
Example: "6 lighting points associated, 0 repeater associated".
Check that:
• the LED of the receivers has stopped flashing.
Repeat the same procedure to associate the lighting receivers of unit 2, by typing #421

8.8 To associate scenarios (4 scenarios can be created)

• Set the receivers to the required status (e.g. light off and roller shutter closed),
• Set the relevant receivers to association wait mode.
• From the main menu,
type #601 for scenario 1, then 1
type #602 for scenario 2, then 1
type #603 for scenario 3, then 1
type #604 for scenario 4, then 1
• The transmitter displays: "Configuring..."
After a few seconds, the transmitter announces the number of receivers found on the installation:
Example: 3 roller shutters associated, 2 receivers associated.
Check that the association was successful:
• the motors briefly start twice
• the LED of the receivers has stopped flashing.
64