Bartscher 200256 Manual De Instrucciones página 51

Indication of required value

shortly press button

press button
Change of required value (required temperature)

press and hold button

the required value will be displayed and the diode

use button
required value;

confirm new value with button
set value.
NOTE!
Other settings and changes of parameters can be found in the
accompanying description of the digital temperature controller and
should be set by specialist staff.
Switching off the device
If a break is expected in using the device, turn it off using the main switch
(position „O" (OFF)) and disconnect from the power supply (pull out the plug!).
NOTE!
Any water accumulated in the bottom of the device can be removed by the
discharge pipe below the device.
Defrosting
Automatic defrosting
The device is automatically defrosted four times within 24 hours. The clock starts
upon first activation. If the automatic defrosting is to be carried out at other times,
for more than 2 seconds. The digital display shows „
press
Defrosting will start right away, the next defrosting will take place after 6 hours.
to show the required temperature;
again or wait 5 seconds to return to the previous indication.
for at least 3 seconds;
or to decrease or increase the value until the display shows the
or
or wait 10 seconds for the automatic storing of
will flash on the display;
".
- 47 -