Installing The Drivers; Windows Xp - Dynex DX-E101 Guia Del Usuario

Dynex5x7-multi.book Page 5 Wednesday, September 14, 2005 9:09 AM
Installing the adapter
3 Connect the other end of the cable to the WOL connector on the system
board.
4 Turn on your computer and press Delete or F1 when prompted to enter the
BIOS Setup utility. The keys you press to enter the BIOS Setup utility may
vary. See your computer's user guide. Enable the WOL function or power-on
function of the computer. The name of this function is system dependent,
but it may be located in a category heading titled such as "Power
Management." See your computer's user guide for more information
regarding the BIOS Setup utility and BIOS settings.

Installing the drivers

W XP
INDOWS
To install the adapter drivers in Windows XP:
1 Make sure that you have installed the adapter into your computer and have
connected the network cable.
2 Turn on your computer. After Windows XP automatically installs the drivers,
a Found New Hardware message appears next to the clock on the Windows
taskbar.
3 If Windows does not automatically install the drivers, follow the
instructions in "Manually installing the drivers in Windows XP" on page 5.
M
ANUALLY INSTALLING THE DRIVERS IN
To manually install the drivers in Windows XP:
1 Click Start, right-click My Computer, then click Properties. The System
Properties box opens.
W XP
INDOWS
5