Klarstein Gran Reserva 166 Manual Del Usario página 31

1. To put the cabinet on open operation place, the door opened to the maximum
angle.
2. Use small knife(2) to take off the decorative nail (1) on opposite side (Drawing 1)
3. Use the inner six angle screwdriver (Tool 5) to disassemble the screws(4) of drop-
proof device (3), then remove the drop-proof device .(Drawing 1)
4. Hold the door, use six angle screwdriver (Tool 5) to screw out the door shaft
core(6) from the two ends of the top of the door. Take out the door and set aside.
(Drawing 2)
5. Discharge the upper and lower door hinge(7)(8) by MS inner six angle screwdriver
(Tool 5) , then to assemble the door hinge on the opposite side. (Drawing 3 and 4 )
6. Rotate the door 180 degrees, then Install the door on the right side of the cabinet.
(Drawing 5)
7. Finally, install the decorative nail and drop-proof device at the opposite side.
(Drawing 6)
EN
31