Publicidad
Idiomas disponibles
Idiomas disponibles
c. Timer setting
Press the "TIMER"
In "RUN" mode, press the "TIMER"
switch off in hours (0, 1, 2......23, 24, 0, 1, ....).
Once the desired value has been selected, wait a few seconds to allow the memorization of the set value after
which the appliance switches off (STANDBY); the "Timer" led switches on in green.
In "STANDBY" mode, press the "TIMER"
pliance start in hours (0, 1, 2......23, 24, 0, 1, ....).
Once the desired value has been selected, wait a few seconds to allow the memorization of the set value after
which the appliance starts (RUN); the "Timer" led switches on in green.
To cancel the Timer function programming, press the "TIMER" key once or more until selecting "0" or press
the "STANDBY" key .
3.1 - BLACKOUT
In case of blackout, the appliance restarts to work in the previously selected conditions when power is re-
stored.
3.2 - WATER UNLOADING
3.2.a - Emptying the tank
• When the led (28) switches on, the appliance stops, the buzzer rings and it is necessary to empty the tank (7).
• Remove the tank (7) from the appliance body working with both hands (Fig.7).
• Empty the tank (7) (Fig.8).
Do not remove the float (7b) from the water tank (7).
The full water sensor won't be able to correctly detect water level anymore.
• Correctly reposition the tank (7) in the appliance body, otherwise the led (28) remains turned on and the
appliance doesn't work.
3.2.b - Continuous water unloading
•
If desired, it is possible to connect the supplied hose (14) to the connection (13) to continuously drain water
collected by dehumidification.
• Switch off the appliance and disconnect the plug from the power socket.
• Connect the rubber hose (14) with an internal diameter of 10mm to the connection (13) (Fig. 9).
• It is advised to fix the hose (14) to the connection (13) using a clamp (not supplied).
• Correctly reposition the tank (7) in the appliance body making the hose (14) pass in specific seat located
in the tank (7). If this operation is not completed, the led (28) remains on and the appliance doesn't work.
Make sure the rubber hose (14) doesn't exceed the exhaust joint height, otherwise
water will remain in the appliance and could cause a malfunction, damage it and/or
cause dangerous work conditions.
During operation with continuous unloading, do not remove the water tank.
key to set the delay time for "RUN" (start) or "STANDBY" (switch off) modes.
key once or more; the display shows the delay time for the appliance
key once or more; the display shows the delay time for the ap-
EN - 20
AQUARIA SLIM
Publicidad
Capítulos
