Setting Operating Mode - Flex CHE 5-40 SDS-max Instrucciones De Funcionamiento Originales

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35

Setting operating mode

CAUTION!
Do not change operating mode until the
electric power tool is at a standstill.
 Turn the rotary knob until it audibly
engages in the required operating mode:
1. Hammer drilling
2. Chiselling
3. Setting the chisel position (see below)
NOTE!
The rotary knob must audibly click into
place in all positions.
Do not switch on the power tool in
the position for setting the chisel
position (3.).
Setting the chisel position
The chisel can be adjusted in 12 positions
(moved 30° in each case).
 Set the rotary knob for operating mode
to the position shown.
 Turn the chisel until the chisel is at
the required angle.
16
 Move rotary knob for operating mode
to the
symbol.
Switching on the power tool
 Press and hold down the switch.
Switch off the machine:
 Release the switch.
Safety clutch
CAUTION!
If the safety clutch trips, switch off the power
tool immediately!
The safety clutch disconnects the motor
from the tool if a preset torque limit value
is exceeded. The insertion tool stops.
As a result, the motor and gears are
protected from damage.
CHE 5-40 SDS-max

Publicidad

Tabla de contenido
loading

Tabla de contenido