Operating Instructions; Changing The Tool - Flex CHE 5-40 SDS-max Instrucciones De Funcionamiento Originales

CHE 5-40 SDS-max

Operating instructions

Before switching on the power tool
Unpack power tool and accessories and
check that no parts are missing or
damaged.
Adjusting the auxiliary handle
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
CAUTION!
Use electric power tool with attached
auxiliary handle only.
The auxiliary handle can be swivelled into
any position to ensure safe and fatigue-free
working.
 Release the clamping by turning the
auxiliary handle counterclockwise (1.).
 Swivel the auxiliary handle into the
desired position (2.).
 Secure the adjustment by turning the
auxiliary handle clockwise (3.).

Changing the tool

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
CAUTION!
Used insertion tools may become hot.
Wear protective gloves!
NOTE!
Tools used must have an SDS-max shank.
Inserting the tools
 Clean and lightly grease the shaft
of the insertion tool.
 Check dust cap.
– Clean dirty cap.
– Have a defective dust cap replaced.
 Insert the cutting accessory (1.) and
turn (2.) until it locks.
 Check lock by pulling on the insertion
tool.
Removing the tools
 Pull locking sleeve backwards (1.).
 Remove insertion tool (2.).
15