Replacement Chain; Storage; Replacement Part And Accessories - Remington RM0815P Manual Del Usario

cLEaNING aND MaINtENaNcE
rEpLacING Saw cHaIN
Replace chain when cutters are too worn to
sharpen or when chain breaks. Only use replace-
ment chain noted in this manual. Always include
new drive sprocket when replacing chain. This
will maintain proper driving of chain. Note: For
proper chain and drive sprocket, see Replacement
Parts and Accessories.

StoraGE

If storing saw for more than 30 days, follow steps
below:
1. Drain oil tank after each use.
2. Remove and clean guide bar and chain. Clean
guide bar and chain by soaking in petroleum
based solvent or mild soap and water mix-
ture.
3. Dry guide bar and chain.
4. Place chain in container filled with oil. This
will prevent rust.
5. Wipe a thin coating of oil over surface of guide
bar.
6. Wipe off outside of saw body. Do this with soft
cloth dampened with a mild soap and water mix-
ture.
7. Store chain saw
• in a high or locked place, out of children's
reach
• in a dry place
rEpLacEMENt partS
aND accESSorIES
warNING: Use only replacement
parts and accessories described in this
manual. Use of other parts or accessories
could damage saw or injure operator.
For original replacement parts and accessories,
call 1-866-206-2707 (in Canada call 1-877-696-
5533) or visit www.remingtonpowertools.com.
1