Description - Hilti HDE 500-A18 Manual De Instrucciones

CAUTION
Draws attention to a potentially dangerous situation
that could lead to slight personal injury or damage to
the equipment or other property.
NOTE
en
Draws attention to an instruction or other useful
information.
1.2 Explanation of the pictograms and other
information
Warning signs
General Warning:
warning electricity
Obligation signs
Wear eye Wear
protection. protective
gloves

2. Description

2.1 Use of the product as directed
The tool is designed to dispense the contents of Hilti foil packs in a controlled operation. The HDE 500 A18
cordless dispenser is designed to be used exclusively to dispense the contents of Hilti 330 ml (11.1 fl.oz.) or
500 ml (16.9 fl.oz.) foil packs. Use of third-party products with the tool is not permissible.
Depending on the type of foil pack, the tool can be used with either a black or a red foil pack holder (see fig. 2).
Black foil pack holder: Used to dispense Hilti mortars supplied in black or white foil packs.
Red foil pack holder: Used to dispense Hilti mortars supplied in red foil packs.
The appliance is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The
appliance and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
Never point the tool toward yourself or other persons.
Do not use the battery as a power source for other unspecified appliances.
Modification of the appliance or tampering with its parts is not permissible.
To avoid the risk of injury, use only genuine Hilti tools and accessories.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction.
Nationally applicable industrial safety regulations must be observed.
2
Printed: 07.07.2013 | Doc-Nr: PUB / 5069911 / 000 / 00
Warning:
caustic
substances
Wear
protective
clothing
Symbols
Read the Return waste
operating material for
instructions recycling.
before use.
"Off" position Continuous
dispensing
Location of identification data on the tool
The type designation and serial number can be found
on the type identification plate on the appliance. Make
a note of this data in your operating instructions and
always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Generation: 01
Serial no.:
National waste
material
recycling
system
Measured
dispensing