Start Up - Truper CM-14N Instructivo

Start Up

Turning On and Operation Control
Switch
• Intermittent Operation:
To turn on the tool, press the switch.
To turn off the tool, release the switch.
• Continuous Operation:
Press the switch until it stops.
The disc will remain rotating until the switch is pressed
again.
Fastening the Work Piece
1 2
1. Lift the half-nut.
2. Pull the crank outwards.
3. Set the work piece.
4. Push the crank until it
touches the work piece.
5. Lower the half-nut.
6. Turn the crank to fasten
the work piece.
3
Half
Crank
Nut
4 5
6
Clamp
Screw
• Set the work piece in a way it cannot move while the disc is
making contact.
• Pieces in an angle shall be worked inverted.
• Cuts will be more efficient if the disc cuts the lowest thickness
section.
• Insert a metallic block slightly smaller than the work piece when
the disc diameter is worn due to wear.
CAUTION
• Never make hands-free cuts if the clamping
screw does not correctly clamp the work piece.
Metallic
Block
7
ENGLISH