Assembly; Cutting Wheel Assembly; Start Up - Truper CAZ-EL-4-1/2N2 Manual De Instrucciones

Assembly

Cutting wheel assembly

WARNING
The cutting wheels size specified for
this tool is 4 1 / ". Never use a different type or size of
2
cutting wheel. Otherwise, severe injury could be caused
or damage to the tool thus making your warranty void.
Never use washers and knobs that are damaged or not
the right size. To get excellent performance and safety
when using the tool, the knobs and washers included are
designed especially.
Use cutting wheels with the right size and shape holes
that fit in the axis. Otherwise they could rotate in an
exocentric manner causing it to go out of control.
• Disconnect the tool.
• Set the cutting wheel in the axis placing it firmly in the
inner flange. Verify that the direction arrow stamped on
the wheel coincide with the arrow embossed in the tool
guard.
• Insert the inner flange in the axis.
• Set the fastening screw in the axis and tighten with the
wrenches.
• To remove the wheels, reverse the steps.
After installing a new wheel, and to verify if the tool is
working correctly, start the tool approximately one minute
without load.

Start up

The tile and masonry saw is a hand held power tool with double insulation. Is used with a diamond wheel designed to cut:
marble, ceramic, tile and similar materials.
CAUTION
This tool is not designed to cut metal or wood.
Switching ON
• Intermittent operation:
Connect the plug into the outlet.
Press switch (A) to start the saw.
To stop just release the switch.
• Continuous operation:
Connect the plug into the outlet.
Press switch (A) and lock it by pushing the continuous use button (B).
To stop, press and then release the switch.
Wrenches to
change the wheel
Cutting disc
Axis
Replace the wheels immediately when worn.
To guarantee a good cut use
only clean, sharp and
properly installed wheels.
Have spare wheels at hand
in order to always have
sharp wheels available.
Fastening
screw
Outer
flange
B
A
7
ENGLISH