Tool Operation; Jam Clearing Procedure - Bostitch GF28WW Manual De Operación Y De Mantenimiento

EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
CAUTION: Additional Safety Protection will be required in some environments. For example,
the working area may include exposure to noise level which can lead to hearing damage.
The employer and user must ensure that any necessary hearing protection is provided and
used by the operator and others in the work area. Some environments will require the use
of head protection equipment.When required, the employer and user must ensure that head
protection conforming to ANSI Z89.1 is used.
Always keep your finger off the trigger, unless contact arm is against the work surface and
you intend to drive a fastener.
This tool has a fan which will turn on whenever the contact arm is depressed. The fan will
continue to run for 10 seconds after the fastener is driven.
SEQUENTIAL TRIP OPERATION:
This tool is equipped with a sequential trigger (GRAY). The contact trip operates in conjunction with the trigger
to drive a fastener. To operate a sequential trip tool:
1. Place tool on the work surface WITHOUT PULLING THE TRIGGER.
2. Completely compress the contact trip.
3. Pull the trigger to drive a fastener.
If the contact trip is allowed to leave the work surface, the sequence described above must be repeated to drive
another fastener.
Disconnect fuel cell and battery before making adjustments or before attempting any part
assembly or disassembly.
On occasion nails can jam in the nose of a cordless tool. This can be caused by striking a metal plate in the
wall, drywall screw, or some other hard object. If this occurs follow these steps.
1. Remove the fuel cell, battery and fasteners from the tool.
2. Open the area of jam. (Fig. 1A for Finish Tools, Fig. 1B & 1C for Framing Tools)
3. Remove the jammed fastener. In certain circumstances, pliers or small screwdriver may be required to
remove the fastener.
4. Close tool.
1A Finish Tools
Lock lever
3
Guide Plate

JAM CLEARING PROCEDURE

1B Framing Tools
-13-

TOOL OPERATION

1C Framing Tools
Convex side