Using & Loading Battery - Bostitch GF28WW Manual De Operación Y De Mantenimiento

TOOL BATTERY
NEVER charge the batteries at a voltage higher than indicated on the nameplate. Charging at
a higher voltage creates fire hazard.
Do not use charger if electrical cord is damaged.
Do not place battery charger under driver's seat (Fig. 2). When charging battery in vehicle,
secure charger using strap supplied. (Fig. 3)
Do not leave battery charger or battery in car.
The battery used in this device may present a risk of fire or chemical burn if mistreated. Do
not recharge, disassemble, heat above 104°F (40°C), or incinerate.
Replace the battery ONLY with the same type of Bostitch battery designed for your tool, use
of another battery may present a risk of fire or explosion.
NEVER charge a battery or leave the battery in direct sun light, it may burst causing injury or
a fire.
NEVER disassemble the battery.
Using the Battery Charger
1. Insert power cord end into charger (for model 9B12071R charger).
2. Insert plug into electrical source.
3. Insert battery into charger (Fig. 1). Indicator light will come on.
4. Indicator light will turn off when battery is fully charged. If light does not go out after 4 hours, unplug
charger and contact Bostitch, as service may be necessary.
5. Remove battery from charger (Fig. 1).
6. Unplug charger when not in use.
NOTE: acceptable temperature range for charging batteries: 32°-104°F (0°-40°C).
Optimizing Battery Performance
1. Recharge batteries before they become completely exhausted. Overdrawing battery power will shorten life.
2. Allow batteries to cool after use before charging. Battery performance will deteriorate if a hot battery is
charged immediately after use.
3. New batteries (or batteries not used for an extended period) may need to be charged 2-3 times before
peak performance is reached.
1
LOADING BATTERY INTO THE TOOL
Never use the tool unless the indicator light is GREEN.
1. Once battery is charged, insert battery into back of tool handle. (Fig. 4)
2. Flashing GREEN light indicates "Ready to drive fasteners". (Fig. 5)
3. Flashing RED light indicates "Battery is empty - Recharge battery"
4. If no light comes on when battery is inserted, either battery is depleted or tool needs service.
5. To remove battery from tool, press battery release button and pull battery out of tool.
4
Handle
Battery
release button
2
Insert
Pull out
Battery
5
Battery indicator light
-8-
3