Operator Troubleshooting; Maintenance And Troubleshooting Chart - Bostitch GF28WW Manual De Operación Y De Mantenimiento

Maintenance chart
ACTION
Clean magazine and pusher
mechanism.
Keep contact arm working properly.

Operator troubleshooting

PROBLEM
Nailer operates, but no nail is driven.
Skipping nails.
Intermittent feed.
Nails jam.
Driven nail is bent.
The operation of the contact arm not
smooth.
Fan is working, light indicator shows
GREEN yet it doesn't drive a nail or
operation unstable.
Fan does not operate when push lever
is pressed.
Unable to charge battery.
WHY
Prevent a jam.
Promote operator safety and
efficient Nailer operation.
CHECK METHOD
Check for a jam.
Check function of pusher.
Ribbon spring weakened or damaged?
Check for proper nails.
Check if the driver blade piston is down Push the driver blade with a slotted-
or not.
Check for proper nails.
Check function of pusher.
Ribbon spring weakened or damaged?
Pusher worn or damaged?
Check for returning of piston.
Check for moving of piston smoothly.
Check for proper nails.
Driver blade worn?
Pusher worn or damaged?
Contact arm bent?
Check contact arm's moving track, debris?
Check for returning of piston.
Check fuel cell, insufficient?
Check spark plug wire, worn out?
Check spark plug, grease or debris?
Check filter, clogged?
Magazine empty.
Note the color of the light indicator.
-16-
HOW
Blow clean daily.
Blow clean daily.
CORRECTION
Clear a jam.
Clean and lubricate.
Replace ribbon spring.
Use only recommended nails.
head screwdriver, and put back the
piston to the highest position.
Use only recommended nails.
Clean and lubricate.
Replace ribbon spring.
Replace pusher.
Pull the trigger all the way.
Too low temperature, warm up
fuel cell under 120°F (50°C).
Contact Bostitch for replacement.
Replace piston ring.
Replace piston.
Replace cylinder piston ring.
Use only recommended nails.
Contact Bostitch for replacement.
Replace pusher.
Contact Bostitch for replacement.
Contact Bostitch for replacement.
Push the contact arm all the way.
Too low temperature, warm up
fuel cell under 120°F (50°C).
Exchange it with a new fuel cell.
Contact Bostitch for replacement.
Contact Bostitch for replacement.
Clean as instructed on the
maintenance sheet.
Load more nails in the magazine.
If red: charge the battery.
If green: Contact Bostitch for
replacement.
Check the electrical cord.