Install The Battery Pack; Remove The Battery Pack; Operation; Important - GreenWorks Pro STC404 Manual Del Operador

EN
8.5

INSTALL THE BATTERY PACK

• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read and understand the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
1
8.6

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (1).
2. Remove the battery pack from the machine.
9

OPERATION

Before you operate the machine, read and understand
the safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

CONTROLS

9.2

START THE MACHINE

1. Push the lock-out button (3) and pull the trigger (4).
WARNING

IMPORTANT

WARNING
English
3
2. Push the speed switch (5) to the desired operating
speed. Push the speed switch to position 1 for low
speed or position 2 for high speed.
9.3

STOP THE MACHINE

1. Release the trigger to stop the machine.
9.4 ADJUST THE LENGTH OF THE
CUTTING LINE
While you operate the machine, the cutting line gets
worn shorter. You can adjust the length of the cutting
line.
1. Hit the trimmer head against the ground while you
operate the machine.
2. Line is automatically released and the cut-off blade
cuts the excess length.
9.5

ADJUST THE CUTTING DIAMETER

The machine is set at a 14 in. (35.6 cm) cutting
diameter. You can adjust to a 16 in. (40.6 cm) cutting
diameter.
Set the cutting diameter to 14 in. (35.6 cm) for greater
runtime and 16 in. (40.6 cm)for a larger cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade
(17).
3. Turn the cut-off blade 180°.
8
4
5
NOTE