Switching The Screen Light Off And On; Mains Electricity Failure; Protection Against Overheating - Haverland ESD Serie Manual Del Usuario

4) Use the "+" and "-" to move the arrow in the upper section until it points to the day of the week. Press "PROG". Each day of the week can
EN
now be programmed.
5) Begin by programming the first band for Monday (1) at 00:00 to 01:00 (the first line flashes).
，
Press
two lines, economy by one and anti-freeze by an empty space (Figure 8).
6) Press the "+" button to select the next time band and repeat the selection process for the desired heating mode. Press "-" to return to the
previous time band.
7) Once all the time bands are set for Monday, the next day can be selected by pressing the "PROG" button. All these steps have to be
repeated in order to programme each day of the week until Sunday is completed. With Sunday fully programmed, the "PROG" button is
pressed to confirm.
PROG
T
Figure 8
These steps complete the heat emitter programming.
If a value is to be modified after programming the emitter, the "PROG" button should be repeatedly pressed until the value to be changed is
reached.
To return to manual mode, press the "PROG" button once.
To modify the temperatures of the various heating modes, change to manual mode (Point 3.1). Select the heating mode (comfort, economy or
anti-freeze) and use the "+" or "-"to select the desired temperature.
To return to automatic mode, press the "PROG" button for at least three seconds.
IMPORTANT NOTE: AFTER TWO OR THREE MONTHS OPERATION, THE HEAT EMITTER CLOCK MUST BE ADJUSTED.

4) SWITCHING THE SCREEN LIGHT OFF AND ON

The LCD screen can be switched off and on using the "SCREEN LIGHT ON/OFF" button (Figure 6).

5) MAINS ELECTRICITY FAILURE

If a power failure occurs, the appliance will be out of service and will come back into operation when the power returns.
All adjustments will remain the same EXCEPT THE CLOCK AND THE CURRENT DAY OF THE WEEK.
If, after an absence from your home it is found that the appliances do not work:
After restoring the mains power supply, start up the heat emitter by pressing "Stand-by" and then set the clock and current day of the week.

6) PROTECTION AGAINST OVERHEATING

Do not cover the emitter. Do not use it to dry clothes. If it is covered, there is a risk of overheating.
The appliance is fitted with a safety device, which will switch it off if overheating is detected.
The appliance will automatically return to service once the problem is resolved.
Repetition of this problem could produce damage and/or faults that are not covered by the guarantee.
or to set the desired mode: comfort, economy or anti-freeze for this time band. The comfort mode is displayed by
ANTI-FREEZE MODE
16