RIB NOVA Wi-Fi Manual Del Usuario página 15

reduce to less than one year.
NOVA Wi-Fi PHOTOCELLS ARE ONLY ON DURING DOOR OPERATION.
THANKS TO THE SLEEP MODE. WHEN THE DOOR IS NOT MOVING THE
PHOTOCELLS ARE OFF TO ALLOW FOR LONGER BATTERY LIFE.
M
OUNTING
N.B.: Before placing the drilling template (code CVA1940) make sure that
the contact surface is clean.
- Affix the plastic bases CPL1312 to the pillars or columns about 40÷60
cm from the ground and at a maximum distance of 10 cm from the
conveyance or pressure area or immediately out of range of any
protruding edge.
- After adjustment attach the protective casing CPL1311.
- Install the NOVA Wi-Fi receiver a maximum distance of 20 m from
NOVA Wi-Fi photocells may be installed very close together thanks to
SYNCHRONIZATION.
SYNCHRONIZATION is guaranteed for up to 2 pairs of photocells with
st
micro-switches 1 ON (1 pair) and 2 ON (2
BC08037R
CPL1311 BC08037T
nd
pair).
TX PHOT 1
TX PHOT 2
RX PHOT 3
RX PHOT 4
They are produced in versions for wall mounting, for mounting to columns of iron
or other smooth material, or on dedicated SUPPORT COLUMNS code ACG8039.
CPL1312
the MASTER Wi-Fi card in order to allow correct radio function and in a
shaded area or in a position not exposed to horizontal sunlight for correct
infrared signal operation.
- In every case it is advisable to place the photocells at the same height
and in line with each other.
- For the correct positioning of the photocells refer to the user installation
manual or to standard EN12445.
Another 2 pairs of photocells may be installed, with transmission/reception
inverted from that of the 2 previous pairs.
The micro-switches must be set: 3 ON (3
RX PHOT 1
RX PHOT 2
TX PHOT 3
TX PHOT 4
15 15
15 15
CPL1940
rd th
pair) and 4 ON (4 pair).
G
B