Water Filtration System; Adding Water And Ground Coffee - Mr Coffee FT Serie Manual Del Usuario

b. Water Filtration System (not included with FTX41CP-NP)
Congratulations! You are the owner
of a MR. COFFEE ® water filtration
system. Using the Mr. Coffee
based water filter in the Mr. Coffee
coffeemaker during the brewing process
helps remove up to 97% of the chlorine
from the water and improves the taste
of your coffee.
First, look for the MR. COFFEE
Friendly symbol on the bottom of
your filter basket. If you do not see this
symbol, please call 1-800-672-6333.
To use the water filtration system in your MR. COFFEE
Coffeemaker, please follow these steps:
1. Align the red indicator on the frame to the
letter that corresponds with the month that
you are using the disk for the first time. This
serves to remind you to change the disk
every month (approx. 30 brewing cycles).
To change the disk, remove the used disk,
insert new disk into the frame.
NOTE: For optimum results, use the water
filtration system with a permanent filter.
2. Rinse the water filter in fresh water before
first use.
3. Follow Adding Water and Coffee instructions.
4. When you are done brewing your coffee, rinse the water
filter with fresh water. Do not put your water
filter in the dishwasher.
C. Adding Water and Ground Coffee
1. Open the brew basket lid. For
your convenience, you can lift out
the removable filter basket.
2. Place a MR. COFFEE brand 10-12
®
12
FT Series_12ESM1.indd 13-14
Red
Indicator
carbon-
®
®
Filtration
®
®
Frame
Filter Disk
cup paper basket-style filter or a MR. COFFEE
filter into the removable filter
basket (Figure 5).
NOTE: If using paper filters, it is
important that the sides of the filter fit
flush against the side of the filter basket.
If filter collapse occurs, dampen the
filter before placing in the filter basket
and adding ground coffee and water.
3. Add the desired amount of coffee
and gently shake to level the coffee. See the
Suggested Coffee Measurement Chart.
4. After following instructions in the Water Filtration
System, place the MR. COFFEE
making sure that the side marked "this side up" faces you
and that the water filter is level.
5. Be sure the removable filter basket is properly centered
and all the way down in the brew basket and close the lid.
6. Fill the decanter with cold, fresh water to the desired
capacity (1 cup equals 5 ounces) For easy and accurate
filling, the water markings on the glass decanter and on the
dual water windows show the amount of water needed to
make the corresponding desired number of cups. Do not
fill past the "12 cup MAX line" or water will flow out of the
overfill hole in the back of the coffeemaker.
The amount of coffee brewed will always be slightly less
than the amount of water poured in the water reservoir.
This is due to the minimum absorption of water by the
coffee grounds.
7. Lift the pour through reservoir lid and pour the water
into the water reservoir. Close the lid and place the
empty decanter onto the warmer plate.
NOTE: Make sure the decanter is fully placed on the warming
plate or the water and the grounds will overflow from the
filter basket. An overflow may cause personal injury or
damage to property.
permanent
®
Figure 5
water filter in the basket,
®
13
3/28/12 2:16 AM