To lubricate the slides of the gliding rack
NV51M9770SM_AA_DG68-00997A-00_EN+MES+CFR.indb 53
1.
Remove the rack from the oven. See
removing the gliding rack in the Using
the gliding rack section on page 39.
2.
Fully extend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy cleanup.
3.
If there is debris in the slide tracks,
wipe it away using a paper towel. (Any
graphite lubricant wiped away must be
replaced - See steps 4 through 7.)
4.
Shake the graphite lubricant before
opening it. Starting with the left (front
and back) slide mechanism of the rack,
place four (4) small drops of lubricant
on the two (2) bottom tracks of the
slide close to the bearing carriers.
5.
Repeat for the right (front and back)
slide mechanism of the rack.
Open and close the rack several times
6.
to distribute the lubricant.
7.
Replace the cap on the lubricant and
shake it again. Turn the rack over and
repeat steps 3, 4, 5, and 6.
8.
Close the rack, turn the rack right-
side-up, and then place in oven. See
Installing the Gliding rack on page 39.
NOTE
•
Do not spray the gliding rack with
cooking spray or other lubricant sprays.
English 53
2017-07-25
5:27:30