Install The Hardware; System Considerations - Axis A1001 Guia De Instalacion

AXIS A1001 Network Door Controller
Supervised Inputs
To use supervised inputs, install end of line resistors. This applies to all supervised inputs. For
information about limitations and updates, see the product's release notes.
i Input
ii
0 V DC (-)

Install the Hardware

CAUTION
Never mount the Axis product while power is applied to the product. Always apply power
at the end of the installation.
NO NO NO TICE TICE TICE
To protect the circuits against electrostatic discharge (ESD), use ESD protection when
handling the product while the components and contacts are exposed.
Read all the instructions before installing the product.
• To configure the hardware, see page 27.
• To install the product on a wall (preferred) or ceiling, see page 28.
• To install the product on a DIN rail, see page 29.
• To connect the cables, see page 30.

System Considerations

The Axis product shall be installed within the secured area.
26