Maintenance Instructions; Further Information - Axis A1001 Guia De Instalacion

Ocultar thumbs Ver también para A1001:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

AXIS A1001 Network Door Controller

Maintenance Instructions

To keep the access control system running smoothly, Axis recommends regular maintenance of the
access control system, including door controllers and connected devices.
Do maintenance at least once a year. The suggested maintenance procedure includes, but is not
limited to, the following steps:
Make sure all the connections between the door controller and the external devices
are secure.
Verify all the hardware connections. This requires access to the product's webpages. For
more information, see the User Manual.
Verify that the system, including the connected external devices, functions correctly.
-
Swipe a card and test the readers, doors, and locks.
-
If the system includes REX devices, sensors or other devices, test them as well.
-
If activated, test the tampering alarms.
If the results from any of the steps above indicate faults or unexpected behavior:
-
Test the signals of the wires using appropriate equipment and check if the
wires or cables are damaged in any way.
-
Replace all damaged or faulty cables and wires.
-
Once the cables and wires have been replaced, verify all the hardware
connections again. This requires access to the product's webpages. For more
information, see the User Manual.
Make sure all access schedules, doors, groups, and users are up to date. This requires
access to the product's webpages. For more information, see the User Manual.
If the door controller is not behaving as expected, see the User manual for information
about troubleshooting and the product's built-in maintenance functions.
For information about maintenance of the battery, see Requirements for UL Compliance on page 4
and Battery on page 8.

Further Information

The User Manual is available at www.axis.com
Visit www.axis.com/techsup to check if there is updated firmware available for your network
product. To see the currently installed firmware version, go to Setup > About.
Visit Axis learning center www.axis.com/academy for useful trainings, webinars, tutorials and
guides.
40

Publicidad

Tabla de contenido
loading

Tabla de contenido