Axis A1001 Guia De Instalacion página 32

AXIS A1001 Network Door Controller
3. Strip the cables and wires as required using a crimp tool.
4. Connect the wires between the door controller and the locks, doors and other devices. For
more information about the connectors and their specifications, see page 16 and page 19.
NO NO TICE NO TICE TICE
• Make sure all the wires are connected correctly. Incorrect wiring could cause damage
to the product.
• Make sure to use wires that meet the requirements. For more information, see Wire Area
on page 19 and, for UL compliance, Requirements for UL Compliance on page 4.
Cable connection example
1
6-pin plug connector
2
Network cable
3
Cable tie (4x)
4
Network connector
4
3
32
2
1