Configuration Of Alpha Ip Base Station - Alpha IP WTHP 61001 Serie Manual Del Usaurio

midity, as required.
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol "
wheel.
• "ACT" for displaying the actual temperature (Default value) or
• "SET" for displaying the set temperature or
• "ACtH" for displaying the actual temperature and the current humidity

6.1.9 Configuration of Alpha IP Base station

This menu allows to configure the Alpha IP Base station in standalone operation.
1. Press and hold the setting wheel (E) in order to open the configuration menu.
2. Select the symbol "
wheel.
If the room control unit is taught-in to more than one base stations, select
the desired base station with the setting wheel.
The device parameters "UnP1/UnP2" and the channel parameters "ChAn" are avail-
able in the configuration menu for the Alpha IP Base station; these parameters al-
low the modification of the pump lead and follow-up times, setback temperatures,
time intervals and many other parameters.
Information on the configuration possibilities can be found in the Alpha IP
Base station instructions.
Operating modes and configuration
" and confirm the selection by shortly pressing the setting
" and confirm the selection by shortly pressing the setting
51