Main Features; Installing The Radio; Installation; Power Supply - Midland M-30 Manual Del Usuario

Main features

• Multi-function CB with 6 programmable channels
• Wide graphic TFT display
• Power supply 12V-24V
• Metal chassis
• Programmable controls
• Channel number or channel number+frequency band displayed
• AM/FM multi-band radio
• Digital automatic squelch adjustable in different levels
• S-Meter/SWR-Meter
• RF-gain
• Scan
• Dual Watch
• Customizable Roger Beep
• Emergency channels 9/19 and priority channel
• Noise Blanker
• Voice enhancer
• Protection against polarity inversion
• 8 memory channels customizable
• Time Out Timer
• Adjustable backlight
• Automatic turning on
• Keypad lock
• Microphone with RJ45 connector and Up/Down/Priority Channel controls
• Software programmable (through the optional programming kit PRG-30 cod.
C1318)
2 | M-30 Instruction Guide

Installing the radio

Installation

• Safety and convenience are the primary considerations for mounting any piece
of mobile equipment. All controls must be readily available to the operator wi-
thout interfering with the movements necessary for safe operation of the vehi-
cle. To install the transceiver select a location that will minimize danger to your
passengers and yourself while the vehicle is in motion; the location should be
well-ventilated and shielded from direct sunlight.
• Install the mounting bracket in the vehicle using the supplied self-tapping
screws and flat washers.
• Install the bracket into the vehicle using the supplied self-tapping screws and
washers.

Power supply

• Be sure the transceiver is off.
• On the rear of the radio you will see a bi-color power supply cable with a fuse
holder on the red cable.
• This cable is supplied with a connector suitable for the connection to the radio
and vehicle's battery.
• In the direct-voltage power supply, it is very important to observe the polarity
even if the unit is protected against the accidental inversion.
• Red = positive pole (+)
• Black = negative pole (-)
• The same colors are present on the battery and in the fuse box of the car. Cor-
rectly connect the cable terminal to the battery.
• The battery of vehicle must have a nominal capacity of 12 or 24V.
• Be sure the battery of the vehicle is able to supply enough power to the radio.
• Connect the DC power cable to the regulated DC power supply and ensure
that the polarities are correct.
ATTENTION: To obtain best performances we recommend installing the radio in a po-
sition with a good air circulation.
M-30 Instruction Guide | 3