Memory Channels; Scan Function - Midland M-30 Manual Del Usuario

Memory channels

M-30 allows you to store up to 8 channels.
The channels let you store the frequency and data. So that you don't have to
re-program the same data repeatedly and you can immediately tune on the desired
channels.
Storing a channel
1. Select the channel you want to store.
2. Set all desired parameters to the channel (AM/FM, HIC, RB, NB).
3. Keep pressed for 2 seconds P6 in menu 2 or the key associated to MEM
function, the channel number will appear on the display.
4. If the channel blinks it means that it is not stored. While if it doesn't, it is alre-
ady stored. It is possible however to overwrite the memory information on the
busy channel.
5. Select the channel number to store (or overwrite) by turning the main knob.
6. To delete the memory, press for 2 seconds
ciated to MEM function, or FUNC on the mike.
Recall a channel
Press P6 in menu 2 or the key associated to MEM function to enter the memory
channels.
Rotate the main knob to select the desired memory channel.
Delete a channel
Press P6 in menu 2 or the key associated to MEM function to enter the memory
channels.
Select the channel to delete.
Keep pressed for 2 seconds P6 in menu 2 or the key associated to MEM function.
16 |
P6 in menu 2 or the control asso-
M-30 Instruction Guide

Scan function

M-30 has 2 types of scan:
• TI: everytime a signal is detected, the radio will stop scanning for a few secon-
ds, then it will start scanning again on the other frequencies even though the
signal is still present.
• SQ: whenever a signal is detected, the radio will stop scanning and will resume
only after the signal disappears.
1. To select the desired type of scan, enter the radio menu and follow these
steps: MENUFUNC MENU  SCM
2. Select the desired option.
3. To start scanning press P6 in menu 1 or the control associated to the SCA
function.
4. To invert the scan direction rotate the main knob.
5. To stop scanning press any key on the front panel or PTT.
Adding a channel to the scan list
1. Select the channel you want to add to the list.
2. Keep pressed for 2 seconds P6 in menu 1 or the control associated to the
SCA function.
3. The display will show SKP: ADD in the lower part and letter S will appear above
the channel (or frequency).
Deleting a channel from the scan list
1. Select the channel you want to delete from the scan list.
2. Keep pressed for 2 seconds P6 in menu 1 or the control associated to the
SCA function.
3. The display will show SKP: DEL in the lower part and letter S will disappear.
Scan resume time
In TI scan mode it is possible to change the scan resume time.
It goes from a minumum of 5s up to 30s.
1. Enter the radio menu della radio and follow this procedure: MENUFUNC
MENUSCRT
2. Press the main knob to enter the options
3. Rotate the knob to select the desired time
4. Confirm by pushing the knob.
M-30 Instruction Guide | 17