Menu Settings - Midland M-30 Manual Del Usuario

Menu settings

With the menu it is possible to customize the functions of the radio and the chan-
nels.
With FUNC and the main knob it is possible to go through the menu and change
the parameters. The main knob in fact is not only a selector but also a control to
enter the menu and confirm the settings.
Going through the menu
1. Press the FUNC key for 2 seconds;
2. Rotate the knob to select the desired function;
3. Press the knob again to enter the options of the selected function;
4. Select the desired parameter by rotating the knob or using the UP/DOWN
controls of the microphone;
5. Push the knob for confirmation.
6. Press the P3 control on the front panel of the radio to go back to the previous
menu.
7. Push P3 again to exit all menu or wait for 5 seconds to return to stand-by
condition.
12 | M-30 Instruction Guide
MENU:
• FUNC MENU (to change the general settings of the radio)
1. BEEP
2. TOT
3. DIM
4. VOL
5. SQL
6. ASQ
7. RFG
• PUD MENU (to change all channels' parameters of the band in use with only
one setting)
1. A/FM
2. NB
3. HIC
4. ROG
CHAN MENU (to change the settings of the channel in use)
•
1. PD
2. SCAN
3. A/FM*
4. NB*
5. HIC*
• DTMF MENU (to change the settings of DTMF codes)
1. DTMF
2. SND-T
3. FIR-T
4. PRE-T
* these options are possible only if PD is set on "OFF".
** KEY MENU allows to set the options or functions on P1-P6 keys.
M-30 Instruction Guide
8. DSP
9. KEY
10. SCM
11. SCRT
12. AOP
13. SWR
14. RST
5. BUSY
6. BOT
7. EOT
8. CALL
6. ROG*
7. BUSY*
8. BOT*
9. EOT*
10. CALL*
5. DELAY
6. D-FUN
7. DISP
8. KEY MENU**
| 13