Eton TRAVELER II DIGITAL G8 Manual Del Proprietário página 8

MEMORIZING FREQUENCIES MANUALLY
The radio can memorize 100 FM, 100 AM, 100 LW and 200 SW (shortwave)
frequencies. To memorize a frequency, with the radio turned on tune to the
frequency of your choice; then follow the instructions below:
1. Press the MEMORY button once and notice the PRESET number flashing in
the upper, right corner of the display.
2. While it flashing, press MEMORY again to store it into the PRESET that's
flashing or wait for 2 second to store it automatically. If you want to store it
into another PRESET just rotate the tuning knob of your choice, and press the
MEMORY button to confirm.
If you've stored frequencies with the ATS button and want to keep them in
memory, be sure to store manually into an empty memory.
MEMORIZING FREQUENCIES WITH THE ATS BUTTON
The ATS button lets you memorize all frequencies of the AM, LW and FM band
with good enough signal strength to be memorized. There are 100 memories,
which are used for manual and ATS storage.
1. Tune to the band of your choice.
2. Then press the ATS button for about 3 seconds, or until you see that it has
started scanning and storing frequencies into memory, shown in the upper
right of the display.
The radio will store as many active frequencies as there are memories for the
band that you're tuned to.
Frequencies that you have stored manually will be overwritten.
Notice: The ATS memory system does not work with SW frequencies.
8
Traveler II Digital G8 OWNER'S MANUAL