Component Description; Lcd Screen Symbol Legend - Webasto SmarTemp Control Instrucciones De Operación Y Instalación

SmarTemp Control

Component Description

On / Off Button
Ambient Temp Sensor
*Micro USB Service Port
* The micro USB Service Port is used for Webasto heater diagnostic purposes only. This adaptor
cannot be used to charge cell phones or other electronic devices.

LCD Screen Symbol Legend

Standby Mode
Heat Mode
Vent Mode
Operation
Using the rotary dial and the selection button (refer to component descriptions), navigation is made
simple. For example, to adjust your heaters set temperature to 70°F with a run time of 4 hours follow
these steps.
1. In HeatMode, use the rotary dial to adjust the set temperature to 70°F; Confirm the adjustment
by pushing the selection button.
2. Press the Selection button. Using the rotary dial, select: Options > Duration > Timed > Adjust
runtime to 4 hours. Confirm the adjustment by pushing the selection button.
Note: While in HeatMode the set temp can always be adjusted quickly by turning the rotary dial to the
desired temperature
LCD Screen
Standby Heater Mode
Ambient Temperature
User Set Temperature
Timed Duration
Ambient Temperature
User Set Temperature
Timed Duration
Ambient Temperature
Fan Speed Indicator
(Low – Medium - High)
Installation - Operating Instructions
Rotary Knob
Screw Cap
Status Indicator Light(s)
Selection Button
Standby Vent Mode
Ambient Temperature
Mode Indicator
Heat ON Indicator
Mode Indicator
Vent ON Indicator
3