Webasto SmarTemp Control Instrucciones De Operación Y Instalación página 4

SmarTemp Control
Mode
Language
Temp Unit
Options
 Duration
 LVD
 Password
 PM Reminder
 Error Codes
Definitions
Mode changes the operation of the heater between heat
mode and ventilation mode. Status indicator lights will
illuminate red for heat mode and blue for ventilation mode
when the selected mode is active.
Language changes between English, Spanish, and French.
Temp Unit changes between Fahrenheit and Celsius units of
measure.
Advanced level adjustments; see below.
Duration allows for the selection of continuous heater
operation or timed operation (30 minutes – 14 hours).
Note: If timed operation is selected 10 hours is default.
LVD "Low Voltage Disconnect" allows the user to adjust the
battery voltage level at which the Webasto SmarTemp Control
will shut down heater functionality.
If battery voltage is equal to or less than the threshold selected
+0.1v, the heater will not start. i.e. if an 11.5v threshold is
selected the heater cannot be started until B+ has reached
11.7v.
12 volt - Range between 11v – 12.5v
24 volt - Range between 21v – 25.5v
A password can be set to prevent access to the advanced
"Options" menu. Enter a 4 digit code passcode to begin
securing Options menu.
Note: This is typically used in fleet vehicle applications.
The product maintenance (PM) reminder will alert the operator
every 30 days with a message to run the heater for 20
minutes. The indicator lights will flash red as a visual reminder.
The operator will have the ability to Start the 20 minute
maintenance cycle or delay it via a "Snooze" option. When
Snooze is selected the PM reminder will postpone until
12:00PM the following day.
This section will log the last 5 error codes and the date that it
was set. Highlight and select an error code for a description.
Note: If the heater or the SmarTemp itself produces an error
code, the status indicator lights will flash red and the error will
display on the main screen. Error codes for the heater cannot
be reset through the Webasto SmarTemp Control. Refer to the
heater service manual for resetting an error code.
Installation - Operating Instructions
4
Default
Heat Mode
English
Fahrenheit
Continuous
11.4v
24.2v
OFF
ON
No Errors