Simplicity SLF4 Manual De Instrucciones página 9

2
Mount the Wall Plate
Solid concrete or concrete block
2-1
Mark the wall
2-2
Drill pilot holes
2-3
Insert anchors and lag bolts
[20]
[20]
6903-002007 <02>
For assistance in determining wall plate location, see Height Wizard at
simplicityav.com
Level the wall plate template [28] and mark the hole locations.
CAUTION:
Mount the wall plate [01] directly onto the concrete surface.
Minimum solid concrete thickness: 8 in.
[28]
Minimum concrete block size: 8 x 8 x 16 in.
CAUTION:
Pilot holes MUST be drilled to a depth of 75 mm (3 in.) using a 10
mm (3/8 in.) diameter drill bit.
Never drill into the mortar between blocks.
75 mm
(3 in.)
Insert lag bolt anchors [20]. Then insert lag bolts [18] through the
wall plate [01] and into the anchors.
CAUTION:
Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage:
13 mm
(1/2 in.)
Avoid potential injuries or property damage!
Avoid potential injuries or property damage!
Avoid potential injuries or property damage!
Be sure the anchors [20]
are seated fl ush with the
concrete surface.
Tighten the lag bolts [18]
only until the washers [19]
are pulled fi rmly against
the wall plate [01].
DO NOT over-tighten the lag
[01]
bolts [18].
[19]
[18]
10 mm
(3/8 in.)
9