Air Bleeding The Fuel System; Checking The Fuel Pipes - KUBOTA Z482-E3 Manual De Instrucciones

A Be sure to use a strainer when filling the fuel tank, or
dirt or sand in the fuel may cause trouble in the fuel
injection pump.
A For fuel, always use diesel fuel. You are required not
to use alternative fuel, because its quality is unknown
or it may be inferior in quality. Kerosene, which is very
low in cetane rating, adversely affects the engine.
Diesel fuel differs in grades depending on the
temperature.
A Be careful not to let the fuel tank become empty, or air
can enter the fuel system, necessitating bleeding
before next engine start.
BAir bleeding the fuel system
To avoid personal injury;
A Do not bleed a hot engine as this
could cause fuel to spill onto a hot
exhaust manifold creating a danger
of fire.
Air bleeding of the fuel system is required if;
A after the fuel filter and pipes have been detached and
refitted;
A after the fuel tank has become empty; or
A before the engine is to be used after a long storage.
[PROCEDURE]
1. Fill the fuel tank to the fullest extent. Open the fuel
filter lever.
2. Loosen air vent plug of the fuel filter a few turns.
3. Screw back the plug when bubbles do not come up
any more.
4. Open the air vent plug on top of the fuel injection
pump.
5. Retighten the plug when bubbles do not come up any
more.
(1) Fuel filter lever
(2) Air vent plug
(3) Fuel filter pot
(A) "ON"
(B) "OFF"
PERIODIC SERVICE
BChecking the fuel pipes
To avoid personal injury;
A Check or replace the fuel pipes after
stopping the engine. Broken fuel
pipes can cause fires.
Check the fuel pipes every 50 hours of operation. When if;
1. If the clamp band is loose, apply oil to the screw of the
band, and tighten the band securely.
2. If the fuel pipes, made of rubber, become worn out,
replace them and clamp bands every 2 years.
3. If the fuel pipes and clamp bands are found worn or
damaged before 2 years' pass, replace or repair them
at once.
4. After replacement of the pipes and bands, air-bleed
the fuel system.
A When the fuel pipes are not installed, plug them at
both ends with clean cloth or paper to prevent dirt from
entering. Dirt in the pipes can cause fuel injection
pump malfunction.
(1) Clamp band
(2) Fuel pipe
13