Handle Installation - Amana ASD2620HRW Guía De Uso Y Cuidado

Installation
Materials Needed
• 1 " outer diameter flexible copper tubing
⁄
4
• Shut-off valve (requires a
water supply line before valve attachment)
• Adjustable wrench (2)
• 1 " hex nut driver
⁄
4
Notes:
• Use copper tubing only for installation. Plastic is
less durable and can cause damage.
• Add 8' to tubing length needed to reach water
supply for creation of service loop.
1. Create service loop with copper
tubing (minimum 2' diameter).
Avoid kinks in the copper tubing
when bending the service loop.
Do not use plastic tubing.
2. Remove plastic cap from water valve
inlet port.
3. Place brass nut (A) and sleeve (B)
on copper tube end as illustrated.
Reminder: Do not use an old
sleeve. The nut and sleeve are
provided in the Use and Care
packet.
4. Place end of copper tubing into
water valve inlet port. Shape
tubing slightly. Do not kink – so
that tubing feeds straight into inlet
port.
5. Slide brass nut over sleeve and
screw nut into inlet port.
Place adjustable wrench on nut
(1) attached to plastic waterline
and maintain position.
Using second adjustable wrench
turn the lower nut (2)
counterclockwise and fully tighten
while holding the upper nut in
place.
Important: Do not over-tighten.
Cross-threading may occur.
1 " hole to be drilled into
⁄
4
2' diameter
minimum
B
A
B
A
6. Pull on tubing to confirm
connection is secure. Connect
tubing to frame with water tubing
clamp (C) and turn on water
supply. Check for leaks and
correct if necessary. Continue to
observe the water supply
connection for two to three hours
prior to moving the refrigerator to
its permanent location.
7. Monitor water connection for 24
hours. Correct leaks, if necessary.

Handle Installation

If not installed, the handle is located in the interior of
the fresh food section or attached to the back of your
refrigerator.
Remove and discard handle packaging and tape.
Handle design varies from refrigerator to refrigerator.
Please reference the appropriate instructions for your
model below.
Plastic Handle
Materials Needed
• Phillips screwdriver
To Install:
1. The handles are to be oriented
as shown.
2. Align door handle clip with the
door studs.
3. Ensure the large hole in the
mounting clip is positioned
down on both ends of the
handle.
1
2
4. Rotate the handle so that the
handle is flat against the door.
C
Door
Stud
6