Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
International Side-by-Side Installation Instructions
Contents
Note
Fresh Food refers to refrigerator.
®
Deepfreeze
refers to freezer.
Introduction
A qualified engineer must connect refrigerator in
accordance with these installation instructions.
Measure door opening and depth and width of
refrigerator. Remove handles or doors as required.
Engineer must also do the following:
1.
Follow local water and electrical company
connection regulations.
2.
Complete water supply connection before
electrical supply connection.
RECOGNIZE THIS
SYMBOL AS A SAFETY
PRECAUTION
Installation Requirements
1.
Install on an earthed outlet with a separate
230 volt, 50 hz., 10A circuit.
2.
Protect soft flooring with cardboard or rugs.
3.
Install on a floor which supports up to 429 kg.
4.
Provide 25 mm clearance on top and 5 mm on
sides of refrigerator.
5.
20 cubic foot Models
Trim corners of counter top to a 45° angle if
counter top has 25 mm overhang.
All manuals and user guides at all-guides.com
Removing Wooden Base
2
2
2
3
3
4
5
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Important
Do not leave refrigerator on its side longer than
necessary to remove bolts.
2
Caution
To avoid personal injury or property
damage, two people must remove
wooden base.
Tape doors shut to prevent doors from opening
unexpectedly.
Slide appliance cart under side of refrigerator.
Wrap refrigerator with blanket or pad. Thread
strap around refrigerator. Put foam shipping
pads, located in shipping carton, under strap.
Tighten strap securely.
Lower appliance cart to floor with appliance cart
handles on bottom.
Remove top two bolts from skid.
Return refrigerator and appliance cart to an
upright position. Remove strap.
Slide appliance cart under opposite side of
refrigerator.
Repeat steps 3-5.
Remove wooden base.
Return refrigerator and appliance cart to an
upright position and remove appliance cart.
Publicidad
Capítulos
Tabla de contenido
