Warranty And Service - Classe CP-65 El Manual Del Propietario

Uni GAIN. The ADJUST feature allows you to
change the input sensitivity for every input
including the tape inputs.
Press the right ARROW key to select the ADJUST
feature and the up and down ARROW keys will
allow you to vary the level by + 12 db. To save
the newly set LEVEL press the ENTER key once
and the bottom of the display will show STORED
and confirm the change. The other LEVEL menu
selection is for UNITY GAIN which allows all
inputs except the TAPE inputs to pass the input
signal to the output unchanged. This allows you
to use you preamplifier in conjunction with an
external Preamplifier/processor for both 2
channel and multi-channel playback. Once you
are in the LEVEL menu use the up or down
ARROW key to select Uni GAIN. Confirm your
selection using the right ARROW key. The display
will show Uni GAIN on top and Mute on the
bottom. The up and down ARROW keys will
allow you to select Mute on or Mute off. This
feature controls the preamplifiers ability to mute
signals when set to unity gain. To confirm your
selection press ENTER and the bottom of the
display will change to STORED.
System Setup and Reset
Press the MENU key on the remote control to
enter SETUP. Once in setup mode the top half of
the display will show SETUP. The bottom of the
display will show INPUTS. Use the up and down
ARROW keys to toggle through the three
available setup menus (INPUTS, SYSTEM,
DISPLAY). Select the SYSTEM menu and confirm
the selection by pressing the right ARROW key.
The display will change to show SYSTEM on top
and VERSION on the bottom. Pressing the right
ARROW key will display the current version of
the software. Pressing the down ARROW will
select the RESET menu. To reset the unit to the
factory defaults press the right ARROW key and
the display will prompt you to press the ENTER
key to confirm that you want to completely reset
the unit.
Note Any changes you have made in setup will
be lost and the system will go into standby mode
once you have confirmed the RESET.
CE CERTIFICATION
As of July 18, 1996, Classé Audio has been
granted:
Certificate Number: C401CLA1.MGS
This indicates CE approval for all models of the
Classé product line.
This means that your Classé product has been
subjected to the most rigorous manufacturing
and safety tests in the world, and has proven to
meet or exceed all European Community CE
requirements.

WARRANTY AND SERVICE

For warranty service, contact your Classé dealer
or Classé Audio directly at:
Classé Audio
5070 Francois-Cusson
Lachine, Québec
Canada H8T 1B3
Telephone: 514 636 6384
Fax: 514 636 1428
Email: cservice@classeaudio.com
Web site: http://www.classeaudio.com
4