Festool CT-F I Manual De Instrucciones Original página 34

English
To be able to connect a remote
control to another mobile dust
extractor, the remote control
must be reset (see section
"Troubleshooting").
► Activate the mobile dust extractor's
automatic mode.
► Press the connection button on the
retrofit receiver module [2-1] for ap­
proximately three seconds until the
LED indicator rapidly starts to flash
[2-2].
The retrofit receiver module is ready for
connection for 60 seconds.
► Press the MAN button [1-3] on the
remote control.
The remote control is permanently
stored in the retrofit receiver module.
34
The mobile dust extractor can be
connected to as many as five re­
mote controls at the same time.
Switching on/off
Once the remote control is connected to
the mobile dust extractor, the mobile
dust extractor can be switched on and
off with the remote control.
► Activate the mobile dust extractor's
automatic mode.
► Press the MAN button on the remote
control [1-2] to switch the device on
and off.
If a mobile dust extractor which
was initially switched on using
the battery pack is switched off