DISSASSEMBLY OF STAGE SYSTEM
• Remove drapes and store on available caddy.
• Disassemble optional ramp system in accordance with
Ramp Owner's Manual and store on caddies.
• Remove guardrails and store them on caddies.
• Remove bridge decks. For storage, one bridge deck
may be placed on top of each of the two decks already
on the master unit, for a total of four decks. To retain the
two piggy back decks when the Roll N Set unit is folded,
the provided deck retainers MUST be deployed. There
are two deck retainers on each side (a total of four)
the must be rotated up as shown to capture the deck
edges; these support the weight of the deck when the
unit is folded for transport and storage. Also, there are
two decks retainers on each end of the unit (a total of
four) that need to be rotated so the tip is above the pig-
gy back deck; these keep the deck from tipping when
the unit is folded for transport and storage. Any extra
bridge decks can be stored on a pallet.
• Remove the bridge bars; two bridge bars can be stored
on each master unit. Reinstall the hitch pins into the
master unit frame.
• Remove and store end to end and side to side
connectors.
• Adjust the stage height to 40" [100cm] or 42" [105cm],
depending on Roll N Set model; adjust the 48"- 72"
[120cm-180cm] model to 48" [120cm]. Use the
procedure outlined earlier in this manual, making sure
to engage the leg lock pins.
• Fold master unit for transport and storage.
• Put the unit up on its casters.
• One person releases the safety latch and
pulls up on the lower lock handle on one
end while another person simultaneously
pulls up on the lower lock handle on the
other end.
• One person on each side pushes down on
the edge of the deck until the unit is folded.
Bridge
Deck
Retainers
A
A
Safety
Latch
B
Lower
Lock
B
Handle
Bridge
Deck
Retainers
Page 13