SICO Roll N’ Set Serie Manual Del Proprietário página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6. As the change in height approaches 12" [30cm] (or
the desired height, if the desired change is less than
12" [30cm]), prepare to engage the leg lock pins by
returning the handle to the horizontal position. Keep
adjusting the height until you hear both leg lock pins
"click" into the engaged position. Rotate the handle
to the vertical down position.
WARNING! Leg pin must be fully engaged
or platform may drop during use and cause
serious injury.
When the leg pin is in the proper
fully engaged position, there is no gap between the
yellow handle and the pin guide bracket.
7. Adjust the other side to the desired height using the
same procedure, making sure the leg pins "click"
into the engaged position and rotate the handles
to the vertical position. Verify that leg pins are fully
engaged.
8. If the first side was not initially adjusted to the
desired height, adjust that side now to the desired
height, making sure the leg pins "click" into the
engaged position. Rotate handles to vertical position
and verify that leg pins are fully engaged.
9. To get the master unit back on its casters, push
down on one of the foot levers until the catch locks
in the elevated position; repeat for the other side.
Fully Engaged Position
No Gap
Disengaged Position
Lock
Pin guide
bracket
Unlock
Page 7

Publicidad

Tabla de contenido
loading

Productos relacionados para SICO Roll N’ Set Serie

Tabla de contenido