Blowing Feature - Workshop WS1100CA0 Manual Del Usuario

SP6854-1 WS1100CA0 Workshop:SP6439-3_ES.qxd 10/14/13 2:44 PM Page 13

Blowing Feature

Your Vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a blower.
1. Locate blowing port of your Vac.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage wear ear protectors
when using the Vac/Blower for
extended hours or when using in a
noisy area.
2. Insert the locking end of the hose
assembly into the blowing port of the
Vac. The hose should snap into place.
To remove the hose from the Vac,
press the release button in the hose
assembly and pull the hose out of the
Vac inlet.
3. (Optional) Attach extension handle to
opposite end of hose, then place the
crevice tool on the wand.
4. Turn Vac on and you are ready to use
your Vac as a blower.
OPERATION (continued)
Locking End
Hose
Assembly
Blowing Port
13