Wolf ICBWWD30 Instrucciones De Instalación página 20

W O L F
I N T E G R AT E D
I N S TA L L F R O N T P A N E L T O D R A W E R
Disconnect the communications line from
communications jack. The communications
jack is removed by depressing retaining clip
from front of mounting panel, then pushing
the retaining clip side of jack through
mounting panel first, then pivoting jack out of
mounting panel. Place removed communica-
tions jack inside drawer frame assembly.
Place the metal panel from the integrated
drawer front onto the back of the decorative
front panel. Trace all of the holes in the metal
panel onto the decorative panel.
Draw a line from the edge of the oblong holes
to the corresponding oblong hole below it.
The markings on the back of the decorative
panel should look like the bottom panel illus-
tration below.
For every round marking on the decorative
panel (12 locations, six for screw heads and six
for the backs of the rubber bumpers), drill a
12.7 mm hole, 6.35 mm deep in the back of the
panel.
20
WA R M I N G D R AW E R
F R O N T P A N E L
Back view of decorative panel
Route out the rectangular areas (8 locations)
marked on the back of the decorative panel
6.35 mm deep.
Attach the handle hardware to the front of the
decorative panel. The integrated drawer front
kit does not include a handle. This allows the
homeowner to match handle hardware with
the surrounding cabinetry.
Using the six screws that came with the
warming drawer, install the metal panel from
the integrated drawer front kit onto the
warming drawer front. Make sure the brushed
side of the metal panel is facing the warming
drawer.
Install the six rubber bumpers, provided with
the warming drawer front kit, onto the metal
panel. Attach the decorative panel to the
warming drawer by screwing through the back
of the warming drawer into the decorative
front panel using the six, 12.7 mm mounting
screws provided with the kit.
Location of bumpers and mounting
screws