Controlling The Camera - Lorex LZC7092B Manual De Instrucciones

6
Controlling the PTZ Camera with your DVR
2. On the DVR, Right-click with the mouse to open the Menu Bar and click
the Main Menu button (
3. Click Device and select the PTZ tab.
4. Configure the following:
• Channel: Select the channel that you connected the PTZ camera to.
• Protocol: Select the protocol (default: Pelco-D).
• Baud rate: Select the camera's baud rate (default: 9600).
• Data Bit: Select 8.
• Stop Bit: Select 1.
• Parity: Select None.
• Cruise: Select Enable to enable PTZ cruise.
• Address: Enter the camera's ID (default: 001).
5. Click Apply to save your settings.

6.3 Controlling the Camera

Note
Turn off motion detection on your DVR for the channel with the PTZ camera connected.
Otherwise, the DVR will detect the PTZ movement as motion. See your DVR's instruction
manual for details.
To control the PTZ camera locally on the ECO Series DVR:
1. Select the channel that the PTZ camera is connected to.
#LX400006; r. 1.0/11219/11445; en-US
).
11