Common Operation - Lenco CS-460 Manual De Instrucciones

2. Common Operation

1. To turn on/off the unit
Under power off mode, press the POWER button to turn on the unit.
Under power on mode, press and hold the POWER button on the front panel or briefly
press the POWER button on the remote controller to turn off the unit.
2. To select function mode
Press the MENU button to turn to mode select, then rotate VOL knob to select TUNER,
DISC(After inserting a disc), USB(After inserting a USB storage), Card(After inserting a SD
card), or AUX mode.
After selecting ,press SEL to confirm and turn to your selection.
3. To adjust sound level
Rotate the VOL knob on the front panel or press the + or - button on the remote controller to
directly adjust the volume level.
4. To mute sound
Press the MUTE button on the remote controller to turn on/off MUTE mode.
Briefly pressing the POWER button on the front panel also can turn on/off MUTE mode.
In MUTE mode, the MUTE mode can be released by pressing the following buttons: MUTE,
VOL or +/-, SEL, MODE.
5. To display and adjust the clock time
Press the CLK button to display clock time on the monitor of the front panel.
To adjust the time, please turn to setup mode time setting.
6. To select a preset EQ mode
Press the EQ button to select the preset music equalizer curves: POP, ROCK, CLAS, EQ
OFF .
The sound effect will be changed.
7. To remove the front panel
Press the REL button on the front panel to detach the front panel from the unit, then you can
remove the front panel.
8. To turn on/off LOUDNESS mode
Press the LOUD button to turn on/off LOUDNESS mode.
When turning on LOUDNESS mode, it will enhance bass level immediately when the bass
is not enough.
9. To reset the unit
when the display is incorrect, or the function buttons are not effective or sound is distorted,
press the REL button to detach the front panel from the unit and remove it, then use the
sharp end of a thing to press the RESET button, which will reset to factory default, and
re-instate the correct functions.
10. To adjust sound modes
To adjust the sound modes, briefly and repeatedly press the SEL button on the front panel to
select one of the sound modes such as : VOL, BAS (without preset EQ), TRE (without
preset EQ), BAL, FAD and EQ.
Note: this function except in play mode select.
8