Ice & Water
Problem
Refrigerator or freezer doors
are not closed properly.
Water filter has been recently
removed or replaced.
Water is not
dispensing.
Tubing connecting refrigerator
to house supply valve is
kinked.
The house water supply is not
connected, the valve is not
turned on fully, or the valve is
clogged.
Refrigerator was recently
installed.
The water dispenser has been
used recently and the storage
tank was exhausted.
Dispensing warm
Dispenser has not been used
water.
for several hours.
Refrigerator is connected to
the hot water supply.
Water supply contains
minerals such as sulfur.
Water filter has been
exhausted.
Water has bad taste
or odor.
Refrigerator was recently
installed.
Possible Cause
• Water will not dispense if any of the refrigerator doors
• After the water filter is replaced, dispense 2.5 gallons of
• The tubing can kink when the refrigerator is moved
• Connect the refrigerator to the water supply and turn
• Allow 24 hours after installation for the water storage
• Depending on your specific model, the water storage
• If the dispenser has not been used for several hours,
• Make sure that the refrigerator is connected to a cold
• WARNING: Connecting the refrigerator to a hot
• A water filter may need to be installed to eliminate taste
• Replacing the water filter is recommended:
• Approximately every six months.
• When the water filter indicator turns on.
• When the water dispenser output decreases.
• When the ice cubes are smaller than normal.
• Dispense 2.5 gallons of water (flush for approximately
TROUBLESHOOTING
Solutions
are left open.
water (flush for approximately five minutes) to remove
trapped air and contaminants from the system. Do not
dispense the entire 2.5 gallon amount continuously.
Depress and release the dispenser pad for cycles of 30
seconds ON and 60 seconds OFF.
during installation or cleaning. Resulting in reduced
water flow. Straighten or repair the water supply line
and arrange it to prevent future kinks.
the water shutoff valve fully open. If the problem
persists, it may be necessary to contact a plumber.
tank to cool completely.
capacity will range from approximately 20 to 30 oz.
the first glass dispensed may be warm. Discard the first
10 oz.
water pipe.
water line may damage the icemaker.
and odor problems.
5 minutes) to remove trapped air and contaminants
from the system. Do not dispense the entire 2.5
gallon amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
61