TCL TTW-08CR/UF Manual Del Usuario página 7

NOTE
• This unit´s increased performance characteristics is the result of having two rear intakes.
• It is very important that these installation instructions are followed so your unit can operate at maximum
efficiency.
• If there is an existing sleeve and rear grille, please check whether the dimension is suitable or not, otherwise
replace them.
Existing Frigidaire sleeves may have older single-sided intake grilles, as below pictures show.
1. These grilles should be replaced with the dual intake grille type, as shown in the pictures below.
• Remove the existing grille and save the mounting screws.
• Place the grille included with your new air conditioner
towards the inside rear of the sleeve.
• Attach the new grille by aligning the four mounting holes.
• Re-insert the self-tapping screws into the nylon retainers.
2. Grille Removal
Important: Single intake grille must be removed when used with dual intake TTW unit.
Warning: When removing grille, protect it from falling by securing with a leash. This can be fastened from cord
or strapping looped through the grille and secured with a knot.
While holding the grille by the leash with one hand, the retaining screws can be removed and the grille can be
brought inside through the front of the sleeve.
5