Finishing The Installation - Sun Blade 1000 Guía De Inicio

Finishing the Installation

1. Remove the antistatic wrist strap from the chassis.
2. Replace the access panel to the chassis and firmly press it closed.
3. If desired, install a lock block on the back panel of the system. The lock block is
shipped in the system ship kit box.
4. Reconnect the system power cord.
5. Reconnect to the system any cables from external devices.
6. Power on the system (see "Powering On the System" on page en-7
Helpful Hint – After you finish installing optional internal components and power
on the system, you are ready to set up the Solaris operating environment software (if
you have not already done so). See "Setting Up the Preinstalled Solaris Operating
Environment Software" on page en-8 for instructions.
For More Information
Refer to the following documentation for more detailed information about system
specifications and service procedures.
Hardware
The Sun Blade 1000 Hardware Documentation CD (part no. 704-6233), which is shipped
with your system, contains:
The Sun Blade 1000 Service Manual. This manual provides detailed procedures for
removing and replacing system components and includes system specifications.
You can also order this manual as hard copy (805-4496), or view it online at:
http://docs.sun.com
The Sun Blade 1000 ShowMe How Multimedia documentation, which demonstrates
service procedures with interactive audio and video animations. These
multimedia procedures are launched from links within the service manual.
Software
Much detailed information about the Solaris software and the additional preinstalled
software on your system is preinstalled on your hard disk. See "Hardware and
Software Documentation" on page en-14.
) .
en-37