Best D49M30SB Manual Del Usuario página 4

(8) #10-24
HEX NUTS
Installations using FLEX BLOWER (in remote location)
or REMOTE BLOWER only:
4. Use the REMOTE DISCHARGE PLATE.
Tighten the hex nuts to secure the REMOTE DISCHARGE
PLATE in place.
Flex Blower
installed.
SUPPORT
LEGS
All Installations:
5. Slide UPPER SUPPORT BRACKETS into SLIDE CHANNEL
at top left and right of unit.
Attach LONG OR SHORT SUPPORT LEGS (depending upon
cabinet height) to bottom sides of unit with HEX SCREWS
provided. Do not tighten hex screws completely at this time.
8" OR 10" ROUND
REMOTE
DISCHARGE
PLATE
(Purchase
separatly)
FRONT
PANEL
CHANNEL
UPPER
SUPPORT
BRACKET
shown
HEX SCREW
1/4-20 X .500
Models D49M30SB • D49M36SB • D49M48SB
#8-32 HEX
NUTS
Installations where ELECTRICAL PANEL needs to be
mounted in a remote location only:
6. Remove (4) #8-32 HEX NUTS and ELECTRICAL PANEL. 5-ft.
extension cables (Model AEWD5 - purchase separately) may
be needed to mount electrical panel in a remote location. Do
not use more than 2 extension cables.
SLIDE
BLOWER
SUPPORT
LEGS
Installations using FLEX BLOWER only:
7. Attach BLOWER SUPPORT LEGS with (4) SCREWS
provided.
!
CAUTION: If flex blower will be mounted
remotely: Do not use legs alone for support. It
may be necessary to add extra support for the
flex blower. Use mounting brackets supplied with
the blower.
Page 4
(4) SCREWS