Best D49M30SB Manual Del Usuario página 5

Installations ducting through left, right or rear only:
(Requires purchase of 1-7/8" x 19" to 8" or 10" round transition.
1-7/8" x 19" rectangular duct and connection adapters are
also available.)
8. Remove only one RECTANGULAR DISCHARGE COVER.
Installations ducting through left, right or rear only:
(Requires purchase of 1-7/8" x 19" to 8" or 10" round transition.
1-7/8" x 19" rectangular duct and connection adapters are
also available.)
9. Use nuts to connect 1-7/8" x 19" rectangular ductwork
connection adapter or 1-7/8" x 19" to 8" or 10" round transition
to housing when installing ductwork.
RECTANGULAR
DISCHARGE COVERS
This
Front Panel
remains
in place.
Ducting out right side of housing shown.
Models D49M30SB • D49M36SB • D49M48SB
CUT COUNTERTOP OPENING
1. Lay out and cut the cooktop cut-out far enough FORWARD so
downdraft will fit behind it.
2. Set cooktop in place and slide it as far forward as possible
without exposing any gaps. Center and square it with edges
of countertop.
COOKTOP
Template against back
edge of cooktop.
3. Place the plastic template against the back flange of the cook-
top or back edge of slide-in range countertop opening. Center
the template. Trace around template to mark the downdraft
opening.
4. Remove cooktop from countertop.
5. Cut downdraft opening. Be careful not to chip edges of countertop.
Page 5
COUNTERTOP
OPENING FOR
SLIDE-IN RANGE
Template against back
edge of countertop opening.