Maintenance; Software Updates; Troubleshooting - Solar PRO-LOGIX PL3730 Manual Del Usuario

Model Number 6V Charging Rates
PL3730
PL3750
CAUTION: Make sure charger is unplugged from AC outlet before performing any cleaning or maintenance.
1. Clean the clamps after each use. Wipe off any battery fluid that may have come in contact with the clamps
to prevent corrosion. Battery fluid may be neutralized with a solution of water and baking soda.
2. Coil the input and output cables neatly after each use. This will help prevent damage to the cables and the
charger.
3. If needed, the case may be wiped clean with a soft cloth.

Software Updates

Any changes made to the primary control microprocessor, for instance, doing repair by an Authorized Service
Center, will result in an update to the latest software version of this product.
The software version is shown on the display when the unit is powered up. To download a specific Operator's
Manual, visit www.cloreautomotive.com. Each product shown includes a copy of the relevant Operator's Manual in
the "Resources" tab.
No digital ammeter reading (battery does not accept charge).
1. Make sure charger is plugged into live AC outlet.
2. After unplugging unit, check connection at battery. Make sure the clamps are making good contact with
the battery terminal (or vehicle chassis).
3. Check to see that the battery is capable of being charged – it may be damaged or sulfated.
4. Make sure that you have selected the proper charge voltage for the battery being charged.
5. Make sure you are allowing enough time for charging the battery. Refer to the charging time formulas
earlier in this manual.
Digital ammeter shows reading, but battery does not accept charge.
1. Check to see that the battery is capable of being charged – it may be damaged or sulfated.
2. Make sure you are allowing enough time for charging the battery. Refer to the charging time formulas
earlier in this manual.
Vehicle will not start in engine start mode.
1. Unplug charger and check connections as described above.
2. Determine if charger is charging; if meter indicates any amperage, charger is working; if no amperage is
indicated, wait several minutes and recheck. Charger thermal protector may have tripped.
3. If engine turns over but does not start, problem is with vehicle, not charger. Service vehicle.
See Limited Warranty for further information on obtaining service.
Table 1. Charging Amp Settings
12V Charging Rates 24V Charging Rates
60/40/15/5A 60/40/15/5A
60/40/15/5A 60/40/15/5A

MAINTENANCE

TROUBLESHOOTING

–
30/15/5A
19
Start
275 Amp 12V
200 Amp 6V
250 Amp 12V
175 Amp 6V