Capital Safety DBI-SALA UCT-300 Manual Del Operador página 2

UCT-300 TRIPOD
SETUP AND WINCH INSTALLATION INSTRUCTIONS
A) Setting up the UCT-300 Tripod
1. Stand collapsed Tripod[1] on fl oor with
feet down (See Fig. 1 ).
2
2. Remove leg retainer pins[2] from 3 places
in tripod head (See Fig. 1 ).
3. Fully spread all 3 legs. Install leg retainer
pins[2] in 3 places to secure legs in a spread
position (See Fig. 2).
4. Remove 3 leg adjustment pins[3] from
legs, and extend legs to fully extended
1
position. Install 3 leg adjustment pins to
secure leg in the fully extended position.
FIG 1
4
5
FIG 3
5. Position tripod over entry ( See Fig.3)
and ensure structure is level. Adjust lengths
of leg(s) as required by removing leg
adjustment pins and extending or retracting
leg(s) as needed. Be careful to reinstall all leg
adjustment pins once tripod is level.
6. Ensure that slack is removed from leg
chain[4] between all legs after setup and
leveling. Adjust chain by loosening quick
connect links at feet[5], and moving quick link
on chain as required.
3
2
2
2
3
FIG 2