Capital Safety DBI-SALA UCT-300 Manual Del Operador página 4

UCT-300 TRIPOD
SETUP & WINCH INSTALLATION INSTRUCTIONS
13
14
FIG 6
B) Installing the Winch to UCT-300 Tripod (c'ont)
4. Remove cable retainer pin[13] from top pulley
assembly[14] and route cable over pulley and
thru head as shown ( See Fig. 6 ).
5. Repeat steps 1 thru 4 as required to install
any other winches and / or fall arrest devices
cable
being used.
6. Refer to the appropriate operators manuals
for instructions on installation, use and
proper maintaince procedures for any and all
accessories being used with the tripod.
4