Capital Safety DBI-SALA UCT-300 Manual Del Operador página 3

6
12
FIG 4
9
8
7
UCT-300 TRIPOD
SETUP & WINCH INSTALLATION INSTRUCTIONS
10
9
8
7
Pin #7 in any
one of these
of 3 holes.
FIG 5
B) Installing the Winch to UCT-300 Tripod
Once tripod has been set up & leveled install
the winch assembly as follows.
1. Select whichever tripod leg you wish to
mount the winch on. This will be infl uenced
by the location of the leg top pulley(s)[6], any
accessories being used with the tripod, and any
obstructions around the work area.
11
2. Remove winch mount pins[7], [8], [9] from
winch mount bracket[10] and position the winch
so that the cable[11 } leaves the winch as shown
(See Fig. 4 ).
3. Slide winch mount bracket[10] over leg
tube[12] (See Fig 5), and position winch where
desired. Install pin[7] through leg bracket and leg
tube using appropriate hole. Install pins[8], [9] as
shown thru bracket and behind leg tube.
See page 3
3